Control4 Zigbee lighting magic tap commands

Zigbee Pro Resets and Magic Button Presses

The following table lists the button sequences to use for Release 1.8.0 and higher
 

Button Tap Functions

In-wall Lighting & Keypads

1-Button Products

Thermostats

System Remote Controls

Zigbee Door Locks

Mini-App Mode

Identify

4

 

(Lighting, 2,3-bkp : Top Button)

(6-bkp : Top Left Button)

4

4

 

(Center Button)

4

 

(Red 4 Button)

4

 

(Left Button)

Press and hold

 

(Bottom Button)

(6-bkp : Bottom Left Button)

Reboot

15

 

(Lighting, 2,3-bkp : Top Button)

(6-bkp : Top Left Button)

15

15

 

(Center Button)

SR-250:
Room Off, #, *, 1, 5, 4, 1, 5


SR-150:
Room off, #, *, 1, 5, 4, 1, 5

N/A

N/A

Channel Blink

7, 4, 7

 

(Lighting, 2,3-bkp : Top, Bottom, Top)

(6-bkp : Top Left, Bottom Left, Top Left)

7

7, 4, 7

 

(First Button Left, Center, First Button Left)

SR-250:

List, Info, Config, 2, 4, 8, 6, #, *

SR-150:

Room Off, #, *, 7, 4, 7

N/A

N/A

Reset Application Defaults

9, 4, 9 or 9, 9, 9

 

(Lighting, 2,3-bkp : Top, Bottom, Top)

(6-bkp : Top Left, Bottom Left, Top Left)

9

9, 4, 9 or 9, 9, 9

 

(First Button Left, Center, First Button Left)

SR-250:
List, Info, Config, Factory Defaults

N/A

N/A

Leave & Reset Factory Defaults

13, 4, 13

 

(Lighting, 2,3-bkp : Top, Bottom, Top)

(6-bkp : Top Left, Bottom Left, Top Left)

13

13, 4, 13

 

(First Button Left, Center, First Button Left)

SR-250:
Room Off, #, *, 1, 3, 4, 1, 3

SR-150:
Room Off, #, *, 1, 3, 4, 1, 3

9 (Right Button)

 

Press and hold
for 13 seconds

 

(Bottom Button)

(6-bkp : Bottom Left Button)

Swap Firmware Image (Legacy Lighting) Hold bottom button while rebooting device, release when LEDs flash purple - - - - -
Swap Firmware Image (Next Gen Lighting) Hold bottom button while rebooting device, release when top LED flashes red 4 times - - - - -
Signal Strength Blink LED's Composer > Network Tools > Zigbee Network - - - - -
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

0 Comments

Please sign in to leave a comment.